Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Parts for Dorchester Homeowners
When a torsion spring snaps or a cable frays, you’re usually stuck with a door that won’t budge and a call to make. We supply and install the exact part your system needs, from torsion and extension springs to cables, drums, rollers, hinges, and seals, and we do it as a standalone service, so you’re never pushed into a full repair call you didn’t ask for. Our technicians have up to 12 years of experience and work on eight major brands, so we know the component before we arrive. We answer 24/7 and offer fast dispatch from 7am to 7pm, Sunday through Friday. Call (855) 500-4346 for a free estimate.
What Our Garage Door Parts Service Includes
Torsion Spring
A torsion spring is the coiled steel bar mounted above the door that stores the energy to lift it, and when it breaks you’ll hear a loud snap and the door will feel impossibly heavy. We replace torsion springs for the brands that dominate Dorchester garages, including LiftMaster openers paired with Clopay and Wayne Dalton doors, and we match the spring to the door’s weight rather than guessing. This is high-tension work, so we handle it directly with the right winding bars and safety procedures – never a job to attempt yourself.
Extension Spring
Extension springs run along the sides of the door and stretch to counterbalance the weight, and they’re common on older sectional doors throughout Dorchester’s triple-decker neighborhoods. When one stretches out or breaks, the door can sag or slam, and the paired spring on the other side usually isn’t far behind. We inspect both, replace them as a matched set when needed, and add the safety cables that keep a broken spring from flying.
Cables & Drums
The cables and drums are what transfer the spring’s tension to the door, and a frayed cable or worn drum is a serious safety issue because the door can drop without warning. If you see a kink, a fray, or a door that lifts unevenly, the cable system needs attention before anything else. We replace cables and drums on Craftsman and Raynor setups among others, and we check the drum grooves for wear so the new cable seats correctly.
Rollers & Hinges
Rollers and hinges are the small parts that carry the door along its track, and when they wear out you get a grinding, shaking door that gets louder every month. Nylon rollers quiet down a door fast, and stiff or cracked hinges can throw the whole panel alignment off. We replace them individually or as a set and lubricate the moving points so the door runs smoothly again.
Weatherstripping
Weatherstripping seals the gaps around the door frame, and in a New England climate it’s what keeps cold drafts, rain, and pests out of the garage. When it hardens, cracks, or pulls loose, you’ll feel the draft and may see water getting in at the corners. We fit new weatherstripping to the frame so the door closes against a clean seal.
Bottom Seal
The bottom seal is the rubber strip along the floor edge, and it takes the most abuse of any part on the door. A torn or flattened seal lets in water, snowmelt, and cold air, and it can also let the door rattle against the floor. We replace bottom seals on the major door brands, matching the profile so it sits flush and the door closes evenly.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Parts
We work on your brand, and we lead with the names because that’s how you’ll recognize whether we can help. We service LiftMaster openers and know where their logic boards and gear assemblies tend to wear out, which saves time when a part needs sourcing. We service Wayne Dalton doors and understand their panel and hardware configurations, so a replacement part fits the first time. We service Craftsman equipment and know the legacy systems that are still running in plenty of Dorchester garages. We service Raynor doors and their track and hardware setups as well.
Our bench knowledge also covers Chamberlain, Genie, Clopay, and Amarr, so whether you have one of those or any other make, we can help. The point isn’t to list every brand – it’s that our technicians have seen enough of these systems to identify a part by sight and confirm the fit before we order or install. That’s what a single-trade garage door specialist brings that a general handyman can’t.
Signs You Need Garage Door Parts Right Now
- A loud snap and a door that won’t lift. That’s almost always a broken torsion or extension spring, and the door is now dead weight. Don’t try to force it open by hand – call us and we’ll get the right spring on site.
- A door that lifts crooked or binds in the track. This usually points to a worn cable, a bad drum, or a bent hinge. Left alone, a binding door can damage the panels and the opener.
- Grinding or squealing as the door moves. Worn steel rollers and dry hinges are the usual culprits, and the noise is your warning that the parts are on their way out. Replacing them early is cheaper than a track repair.
- A visible fray or kink in the cable. Cables under tension can fail suddenly, so any fray is a stop-and-call issue. This is one of the clearest “get a professional” symptoms on any door.
- Drafts, water, or daylight under the door. A hardened weatherstrip or flattened bottom seal means the door isn’t sealing. New seals close that gap and keep your garage dry.
Our Garage Door Parts Process – Step by Step
- 1
You call and describe the symptom. Tell us what the door is doing – won’t lift, grinding, crooked, drafty – and we’ll ask a few questions to narrow it down before we arrive.
- 2
We diagnose on site. Our technician inspects the springs, cables, drums, rollers, hinges, and seals, and confirms the door’s weight and brand so the replacement part is the right one. We test the opener and balance the door by hand to see where the resistance is.
- 3
We quote the part and the labor in writing. You get an upfront price before any work starts, and the written estimate is what sets the final cost. If you only need the part and not a full repair, we can supply it on its own.
- 4
We install and test. Once you approve, we fit the part, check the door’s balance and travel, and run it through open-and-close cycles to confirm it works. For spring and cable work, we follow the high-tension safety procedures the job demands.
- 5
We walk you through what we found. You’ll know what was replaced, what to watch for, and whether any other part is near the end of its life. No surprises on the invoice.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Parts Cost in Dorchester?
A typical torsion or extension spring repair in Dorchester runs $180 – $340 for one spring, and since matched springs are usually replaced together, a pair costs about twice that. Cable repair runs $130 – $250, roller replacement $110 – $220, and a panel replacement $250 – $500. The full range for garage door repair work in Dorchester sits at $150 – $600 depending on what’s involved.
| Part / Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Roller replacement | $110 – $220 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Garage door repair (overall) | $150 – $600 |
What affects the price: the part itself, the door’s size and weight, how much labor the job takes, and whether the opener needs adjusting afterward. The best way to avoid overpaying is to get a written estimate upfront that lists the part and the labor separately – you’ll see exactly what you’re paying for. Our free estimate covers the on-site diagnosis, the part identification, and a written price before work begins. The written estimate sets the final price, so there’s no invoice surprise when the job is done.
Garage Door Parts Near Dorchester – Our Service Area
We cover Dorchester and the neighborhoods around it, including Mattapan, Roxbury, Mission Hill, the South End, Back Bay, Fenway, Beacon Hill, the North End, and Allston. If you’re nearby and need a part sourced or a repair done, we can help – take a look at our garage door parts page for the Dorchester overview, or the garage door parts and garage door parts pages for those areas. Response timing depends on the day and the job, so call and we’ll find you the next opening.
Serving Dorchester, MA – Our Local Coverage Area
We serve Dorchester and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Parts in Dorchester
Garage door parts service is the sourcing and installation of specific components – springs, cables, drums, rollers, hinges, weatherstripping, bottom seals, and panels – rather than a whole new door. We diagnose the failed part, identify the right replacement for your brand and door weight, and install it. If you only want the part without a repair visit, we can supply that too.
Most single-part repairs take a short visit, while spring pairs and cable jobs take longer because of the safety setup and testing. The exact time depends on the door and what’s being replaced. We’ll give you a realistic time when we quote the job.
Typical estimated ranges are $180 – $340 for one spring (a pair costs about twice that), $130 – $250 for cable repair, $110 – $220 for rollers, and $150 – $600 for general door repair. The written estimate sets the final price before any work starts. Call (855) 500-4346 for an exact quote – estimates are free.
Yes, we service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment. We know where each brand tends to wear and how its parts fit, which cuts down on wrong-part callbacks. Whatever make you have, we can help.
Same-day service is often possible, and we answer 24/7. Fast dispatch runs 7am to 7pm, Sunday through Friday, and we’re closed Saturday. A call outside dispatch hours is booked into the next opening.
We stand behind the parts and labor we provide, and the details are laid out in your written estimate. Ask your technician what the warranty covers for the specific part on your door. If something isn’t right, call us and we’ll make it right.
Clear the floor under and around the door so the technician has safe access to the springs, tracks, and opener. Don’t try to force a stuck door open, and keep people and pets clear while we work. Have the door’s brand and any opener model info ready if you have it.
Schedule Your Garage Door Parts Service in Dorchester Today
If a part has failed or is about to, the right fix starts with a call. We’ll diagnose the problem, quote the part and labor upfront, and install it correctly. Call (855) 500-4346 for a free, no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. You can also see our full Garage Door Repair Dorchester services if the job goes beyond a single part.
Written by the team at Garage Door Repair Dorchester.